Installing The Remote Lever [Two In One]; Installing The Pipe, Cable And Cable Housing - DT SWISS O.D.L Technical Manual

6.3.2 Installing the Remote Lever [Two In One]

General Information: Two In One-Lever:
• The remote lever can be used for DT Swiss forks and/or DT Swiss shocks.
• The remote lever must be installed on the left top side of the handlebar.
• The remote lever is designed for a handlebar diameter of 22.2 mm. If the diameter of the
handlebar is smaller, the clamp of the remote lever cannot be fixed strong enough.
1. Carbon handlebars: Apply a thin layer carbon
fitting lubricant on the contact area of remote
lever and handlebar.
2. Put the remote lever onto the handlebar and
tighten the fixing screw with a torque of 1.3 Nm.
3. Check the proper function of the remote lever and
the control elements next to it.
Neither the remote lever nor any other control
element may be affected in its proper function.
4. Push the remote lever in the position «OPEN» (see
figure).
5. Cut the cable housing to the required length.
Check if the handlebar with the installed cable
housing can be turned without being affected.
6. Put the cable into the remote lever.
Only use uncoated cables!
6.4

Installing the Pipe, Cable and Cable Housing

1. Put the pipe into the cable guide on the fork
crown.
2. Screw in the adjusting screw of the pipe
completely and then turn it back one turn.
O.D.L - Technical Manual 43