Operation - Gastroback DESIGN BISTRO OVEN ADVANCED PRO Operating Instructions Manual

• To ACTIVATE the child lock: press and hold the buttons START and PAUSE/STOP at
the same time until a beep sounds and the display shows the lock symbol
• To DEACTIVATE the child lock: press and hold the buttons START and PAUSE/STOP
at the same time again until the lock symbol
the clock will be shown (standby mode). Thereafter, the oven can be used again.
IMPORTANT:
At power up, the oven will always switch to standby mode with the clock
shown on the display and ready to use. Thus, if the power supply is interrupted and re-
established again while the child lock is active, the child lock will be deactivated!

OPERATION

WARNING:
Always ensure that the appliance and all its parts and accessories are
out of reach of young children. Your new » Design Bistro Oven Advanced Pro « is inten-
ded for cooking edible food. Thus, the parts of the oven cooking utensils and food are
heated to very high temperature. Be careful, when removing your food. Use oven mitts
or oven cloths to avoid burns and scalds.
Be careful when opening the oven door. Large amounts of steam could escape from the
heating compartment and cause serious burns on face or hands.
Do not insert any foreign objects as knives, spoons, or other cooking utensils in the oven,
to avoid risk of fire, electric shock, burns or damage. Always handle with care, espe-
cially, when removing burned food.
IMPORTANT: Ensure that the crumb tray is in place at the bottom of the heating compart-
ment before operating the oven. Otherwise crumbs may become charred on the bottom
of the heating compartment, stick to the surfaces and even catch fire.
Do not move or tilt the appliance during operation. Do not place any clothes or tissue or
other foreign objects on or under the appliance during operation, to avoid risk of fire,
overheating, or electric shock. Do not block the ventilation slits of the housing. During
operation, the operating elements must be accessible all the time. See: 'Knowing Your
» Design Bistro Oven Advanced Pro «'.
Ensure to keep the appliance in an appropriate distance of at least 10 cm on each side
to the edge of the working space and any other objects or walls. During operation leave
at least 10 cm of free space above the appliance for unhindered ventilation.
Before operating the appliance, always ensure that all parts are in proper working order.
(See: 'Important Safeguards for Daily Operation') Especially ensure that the front door is
not damaged in any way and closes properly. Only use heat-resistant cooking utensils,
containers and dishes.
Exclusively use the appliance for heating and cooking of food according to the instruc-
12
.
will disappear from the display and
tions in this booklet. The appliance is NOT suited for heating or storing any other mate-
rials.
Cooking can be temporarily interrupted any time by pressing the PAUSE/STOP button.
To stop the cooking completely, press the PAUSE/STOP button twice. See: 'Interrupting
Operation'.
The » Design Bistro Oven Advanced Pro « has a child safety lock. See page 40: 'Acti-
vating the Child Lock'.
During a cooking procedure you cannot operate any other buttons then the START and
PAUSE/STOP button. To operate the other buttons, cooking must be finished either auto-
matically via the timer count-down or by pressing the PAUSE/STOP button twice.
Using the Tray Handle
You can use the handle to hold the food tray when hot. For this, hook the tray handle
onto the edge of the food tray.
ATTENTION: Make sure that the handle is hooked on correctly and that you hold the
food tray horizontal. Otherwise the food tray could slide away and fall. According to
this, you could unintentionally touch hot parts and get burnt.
Setting the Clock
When power is connected and the oven is in standby mode, the clock will be shown
on the display. To set the clock:
1. Press the TIME button. The hour digits will flash. Turn the selection dial to set the hour.
2. Press the TIME button. The minute digits will flash. Turn the selection dial to set the
minutes (0 to 59).
3. Press the TIME button again to confirm the setting. The colon will flash to show that
the clock is running.
You can toggle the time display from 24-hours to 12-hours and vice versa. For this, hold
the TIME button pressed for 2 seconds. Beneath the time display, the new display mode
will be flashing for 5 seconds (12h or 24h).
Interrupting and Cancelling Operation
You can interrupt operation at any time you like. This is helpful, if your food needs turning
and the oven shall not heat needlessly.
1. Press the PAUSE/STOP button during operation. The oven will beep once and stop
working. The display starts to flash.
13