Table of Contents
Advertisement
Non-Threaded Pedal Sensor - Installation
1
Install the Pedal Sensor into the non-drive
side crank spindle.
Threaded Pedal Sensor - Installation
Install the Pedal Sensor into the non-drive
side crank spindle.
3
0.56 N·m
4
(5 in-lb)
Tighten the expander wedge bolt to the specified torque.
NOTIC E
To avoid damage to the expander wedge, do not over tighten the
expander wedge bolt.
Install
While pressing the end of the Pedal Sensor
into the crank with your thumb, tighten
the expander wedge bolt to the specified
torque.
1
Thread the Pedal Sensor into the crank until
it is hand tight.
Adjust
3
0.56 N·m
4
(5 in-lb)
To avoid damage to the expander wedge,
do not over tighten the expander wedge
bolt.
2
To avoid damage to the seal tube, do not
over tighten. Confirm the crank is flush
against the bottom bracket and that there
is no side to side movement.
Tighten the crank pinch bolts to the crank manufacturer's torque
specification.
N OT ICE
To avoid damage to the crank arm, do not over tighten the pinch
bolts.
2
NOTICE
N OTI CE
4
5
Torque
38
Advertisement
Table of Contents
