Calibrate the System
To ensure the system is set up correctly for the bicycle, Flight Attendant must be calibrated once per bicycle installation or component
replacement, and before the bicycle is ridden.
The system can be calibrated only after all components have been paired, and can be recalibrated at any time after the first system
calibration.
Auto mode cannot be enabled until Flight Attendant has been Calibrated.
Prepare for Calibration
Find an indoor level surface for accurate calibration.
Calibrate
Calibration begins from Manual Mode (OPEN).
Measure
Position the bicycle upright 90° on a flat level surface with the
handlebars even.
1
CALIBRATE VERTICAL: Lower the seat and sit on the bicycle with
the front and rear suspension compressed in the sag position.
Important: Front and rear suspension spring air pressure must be
set before calibration.
Adjust
21