SRAM RockShox Super Deluxe Flight Attendant User Manual page 25

Calibration Troubleshooting
System Time Out (Red LEDs):
If Calibration is not successful after 25 seconds during Vertical or Tilt Calibration, the OPEN,
PEDAL, and LOCK LEDs will flash Red simultaneously.
When the Red LEDs stop flashing, Calibration is canceled and the system will return to the
previously active mode.
Re-start the Calibration process.
Exit (Red LEDs):
If any button on the Flight Attendant Control Module is pressed during Calibration, the OPEN,
PEDAL, and LOCK LEDs will flash Red simultaneously.
When the LEDs stop flashing, Calibration is canceled and the system will return to the
previously active mode.
Re-start the Calibration process.
Rear Shock Error (Cyan LEDs)
If the rear shock was not detected during calibration, the OPEN, PEDAL, and LOCK LEDs
will flash Cyan simultaneously.
Wake the rear shock with movement and re-start the
shock battery charge level if the rear shock does not awaken.
Calibration process. Check the rear
25