1
CALIBRATE TILT: When the OPEN
LED pulses White slowly, unweight the
suspension and stand over the bicycle.
4
The OPEN LED will then pulse Green to indicate system Calibration is complete.
Repeat the Calibration process to improve accuracy if 1) the bicycle moved while holding steady during Vertical and Tilt Calibration, 2) front
and/or rear shock air spring pressure and sag is changed, 3) any Flight Attendant component is replaced, 4) wheel size is changed, or 5) fork
travel is changed.
Repeat the
Calibration
procedure as needed.
Measure
2
Slowly start to tilt the bicycle toward the
non-drive side and hold it steady.
Adjust
3
Hold the bicycle steady in the tilted position
with the handlebar straight.
When the OPEN LED blinks White quickly,
Tilt Calibration is successful.
23