Flight Attendant Setup
Component Serial Number Identification
Setup Process
After all components and fully charged batteries have been installed,
complete the setup process before first use.
Activate Pedal Sensor
A new Pedal Sensor ships in a non-active state and must be activated before it can be paired into the Flight Attendant system.
Press and hold the AXS button for 5 seconds until the LED illuminates, then release. The Pedal Sensor is now ready to be paired.
A Pedal Sensor only needs to be activated once.
Press & hold
Locate and record the AXS serial number on the Flight Attendant Control Module.
The serial number can be used in the AXS app to identify the Flight Attendant Control
Module.
All paired components in the system will be linked to the Control Module.
1. Activate the Pedal Sensor
2. Pair the system
3. Set suspension air pressure
4. Calibrate the system
5. Select Bias Adjustment
6. Set Low Speed Compression (LSC) damping (front and rear)
16