KidKraft MCKINLEY F24950 Installation And Operating Instructions Manual page 32

Step 13: Rock Wall Assembly
Fig. 13.1
2605
S20
x 4 per
board
A: Lay 2 (0349) Rock Rails down, side by side with angled edges
facing down. (fig. 13.1)
B: Place (2605) Access Board on the bottom of each (0349) Rock Rail
as shown in fig. 13.1. Make sure (2605) Access Board is flush to the
outside and bottom edges of each (0349). Attach using 4 (S20) #8 x
1-3/8" Wood Screws.
C: 7-5/8" down from the top of both (0349) Rock Rails place 1 (2604)
Rock Board B, making sure the sides are flush to the outside edges of
each (0349) Rock Rail. Attach using 4 (S20) #8 x 1-3/8" Wood Screws.
(fig. 13.1)
D: In between the (2605) Access Board and (2604) Rock Board B
stagger 2 (2604) Rock Board Bs and 2 (2603) Rock Board As using
4 (S20) #8 x 1-3/8" Wood Screws per board. Placing them as shown
in fig. 13.1, this will prevent rocks from forming a straight line. Make
sure the boards are evenly spaced and do not exceed 2-3/8" between
boards.
3/16" Flat
Washer
1/4" Barrel
Nut
Wood Parts
1 x Access Board 1 x 6 x 19-3/4"
2605
3 x Rock Board B 1 x 6 x 19-3/4"
2604
2 x Rock Board A 1 x 6 x 19-3/4"
2603
2 x Rock Rail 2 x 3 x 51"
0349
2603
2604
Note: Gaps between boards 2-1/4",
not to exceed 2-3/8"
1/4" Lock
Washer
PB2
S10
Rock
24 x S20
5 x
S10
5 x
PB2
2603
2604
Fig. 13.3
E: Place 1 rock on each (2603) Rock Board
A and (2604) Rock Board B (fig. 13.2) and
attach using 1 (PB2) 1/4 x 1-1/4" Pan Bolt
(with lock washer, flat washer and barrel nut)
and 1 (S10) #8 x 1" Pan Screw per rock. The
Screw must be in the hole directly under the
Pan Bolt, it will stop the rock from spinning.
(fig. 13.3)
Hardware
#8 x 1-3/8" Wood Screw
#8 x 1" Pan Screw
1/4 x 1-1/4 Pan Bolt
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
32
Note: The holes
in the rock boards
0349
must orient to the
2604
top of the boards.
7-5/8"
Approx
Fig. 13.2
Other Parts
5 x Rocks (3 green/2 yellow)