KidKraft MCKINLEY F24950 Installation And Operating Instructions Manual page 16

Step 2: Frame Assembly
Part 1
It is important to assemble the frame on a flat, smooth surface.
A: Place (2627) SW Wall Panel between 2 (2618) Front Back Panels noticing the panel orientations. The tops
and bottoms of the panels should be flush. Make sure the panels are square then using the pilot holes as a
guide pre-drill with a 3/16" drill bit and fasten the front (2618) Front Back Panel to (2627) SW Wall Panel and
(2627) SW Wall Panel to the back (2618) Front Back Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags per side. (fig.
2.1, 2.2 and 2.3)
Fig. 2.1
Top View
2618
Front
Notice front
(2618) Front
Back Panel
overlaps (2627)
SW Wall Panel
WL5
Flush
Fig. 2.2
Flush
2627
Swing Wall
Notice counter sunk
holes on the outside
Wood Parts
2 x Front Back Panel 1-1/4 x 42 x 87"
2618
1 x SW Wall Panel 1-1/4 x 42 x 87"
2627
2627
Swing Wall
Front
2618
8 x
2618
Back
Notice (2627) SW Wall
Panel overlaps back
(2618) Front Back Panel
Flush
WL5
Flush
Hardware
1/4 x 2-1/2" Wafer Lag
WL5
16
Fig. 2.3
Notice grooves
face inwards
2618
Back
WL5
x 4 per
side