KidKraft MCKINLEY F24950 Installation And Operating Instructions Manual page 26

Step 9: Install Ground Stakes
A: In the 5 places shown in fig. 9.1 drive the Rebar Ground Stakes 13" into the ground against outside front corner
of (2622) End Panel Assembly, on both (2607) Diagonals and both (2613) Heavy SW Posts. Be careful not to hit
the washer while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw per ground stake (fig. 9.2 and 9.3).
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
be driven 13" into ground. Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables or gas lines.
Fig. 9.1
2613
SEE FORT GUIDE SHEETS
FOR SAFETY CLEARANCE
AND FORT ORIENTATION
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes must
Front
2607
2607
5 x
2622
Hardware
#12 x 2" Pan Screw
S7
26
Fig. 9.2
Fig. 9.3
S7
Rebar
Ground
Stake
Other Parts
5 x Rebar Ground Stake
2622
S7
Rebar
Ground
Stake