KidKraft MCKINLEY F24950 Installation And Operating Instructions Manual page 21

Step 4: Attach SW Ground and Diagonal
A: Loosely attach 1 (2606) SW Ground to each (2607) Diagonal with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock
washer, flat washer and t-nut) per board then place each (2607) Diagonal tight and flush to the front of (2627) SW
Wall Panel. (2606) SW Grounds to be flush to the bottom of (2627) SW Wall Panel. (fig. 4.1 and 4.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach each (2607) Diagonal to (2627) SW Wall Panel with 1 (LS3)
1/4 x 3" Lag Screw (with flat washer) per board, checking that they remain flush to outside edge. (fig. 4.1 and 4.2)
C: Make sure bottom of each (2606) SW Ground is flush to bottom of (2627) SW Wall Panel then attach with 2
(S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw per board. Tighten all bolts. (fig. 4.1 and 4.2)
Fig. 4.1
Wood Parts
2 x SW Ground 5/4 x 4 x 14-1/4"
2606
2 x Diagonal 1-1/4 x 3 x 22"
2607
2627
2 x
2 x
2 x
4 x
2627
S11
Flush
S4
Hardware
H10
1/4 x 2-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 3" Lag Screw (1/4" flat washer)
LS3
#8 x 3" Wood Screw
S4
#8 x 2" Wood Screw
S11
21
1/4" Flat
Washer
Flush
1/4" Lock
H10
Washer
2606
Fig. 4.2
LS3
2607
1/4"
T-Nut
1/4" Flat
Washer