KidKraft MCKINLEY F24950 Installation And Operating Instructions Manual page 23

Step 6: Swing End Assembly
A: Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with
lock washer, flat washer and t-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of angle.
(fig. 6.1)
B: Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) 5/16 x 4"
Hex Bolts (with lock washer, flat washer and t-nut). Tighten all bolts (fig. 6.1)
C: Install 2 (WB7) 5/16 x 3" Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (2615) SW Upright
as shown in fig. 6.1. IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Fig. 6.1
2613
Wood Parts
2 x Heavy SW Post 2 x 3 x 86-11/16"
2613
1 x SW Upright 4 x 4 x 50-15/16"
2615
1 x SW Support 5/4 x 4 x 46-1/2"
2616
5/16"
T-Nut
5/16" Flat
Washer
5/16" Lock
Washer
2 x G7 5/16 x 5-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
3 x 5/16 x 4" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
G4
2 x 5/16 x 3" Wafer Bolt (5/16" flat washer & 5/16" t-nut)
WB7
2616
2615
G4
Hardware
23
5/16" Flat
Washer
WB7
5/16"
T-Nut
G7
5/16" Flat
5/16" Lock
Washer
Washer
Notice 2 bolt
holes at top and
orientation of
the angle
5/16"
T-Nut