IQ9 Residual Image (Ghosting) RAP
The image from a previous print appears on the current print
Procedure
Switch Off the Power.
Check the Transfer Roller for the following
•
Wear or damage.
•
The left and right tension springs for damage.
•
Be sure all parts are installed correctly.
The Transfer Roll is OK.
Y
N
Replace the Transfer Roll;
(REP
1.17),
If problem persists, Replace components in the following order:
•
Print Cartridge, refer to WorkCentre® 3025 User Guide for detailed instructions on how to
replace the Print Cartridge.
•
Fuser Module;
(REP
1.19),
PL
5.2.
•
LVPS / HVPS PWB;
(REP
1.6),
PL
Figure 1 Ghost Image
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
(Figure
1).
PL
5.1:
PL
5.1.
5.1.
IQ10 Side 2 Staining
Side 2 of a simplex print is stained
Procedure
Switch Off the power. Check the Transfer Roller for wear or contamination. The Transfer
Roller is OK.
Y
N
Replace the Transfer Roll;
If problem persists, replace the Fuser
June 2014
3-9
(Figure
1).
(REP
1.17),
PL
5.1.
Module;(REP
1.19),
PL
5.2.
Figure 1 Side 2 Staining
Image Quality
IQ9, IQ10