Ice Maker Installation; Unpacking; Remove Packaging Material; Location Requirements - Maxx Ice MIM452 Service, Installation, And Instruction Manual

Ice Maker Installation

UNPACKING

Use two or more persons to move and install ice maker
Failure to do so can result in back or other injury
This unit is an ice maker only. It requires a separate ice storage bin.
REMOVE PACKAGING MATERIALS
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using,
• To remove any remaining tape or glue, rub the area briskly with your thumb Tape or glue residue
can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry with a soft cloth.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue These products can damage the surface of your ice maker

LOCATION REQUIREMENTS

• This ice maker should be installed by qualified personnel.
Installation Clearance
2 3/8 "
Minmimum
to wall: 6 "
Area for
dispensing ice
cubes to bin
SERVICE AND INSTALLATION MANUAL
DANGER
WARNING
Excessive Weight Hazard
CAUTION
Top View
20 7/8"
6 5/8"
Rear of machine
maxxfoodservice.com
Minmimum
to wall: 6 "
6