Table of Contents
Advertisement
This chapter contains instructions for the following items:
•
Unpacking the DELHF (Section 2.1)
•
Installing FPIMs (Section 2.2)
•
Installing a DELHF (Section 2.3)
To install the DELHF and FPIMs, you need the following items:
•
Antistatic wrist strap (provided with the MultiSwitch 700 chassis or
standalone hub)
•
Phillips screwdriver
The DELHF-UA and the host module or hub are sensitive to
!
static discharges. Use a grounding strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the DELHF-UA, host module or hub.
2.1
UNPACKING THE DELHF
Unpack the DELHF-UA as follows:
1. Remove the shipping box material covering the DELHF-UA.
2. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install it.
3. Attach the antistatic wrist strap. If the HSIM is to be installed in a
standalone hub, refer to the instructions on the antistatic wrist strap
package. If the HSIM is to be installed in an interface module, refer to
the applicable interface module User's Guide.
4. After removing the module from its non-conductive bag, visually
inspect the device. If you notice any signs of damage, contact your
DIGITAL representative.
DELHF-UA User's Guide
CHAPTER 2
INSTALLATION
2-1
Advertisement
Table of Contents
