Table of Contents
Advertisement
3.9.3
Configuring the DELHF-UA for Full Duplex
Operation
To configure the DELHF-UA to operate in full duplex mode, complete
the following steps.
1. Use the arrow keys to highlight the [STANDARD FDDI] field.
2. Use the SPACE bar to toggle between [STANDARD FDDI] and
[FULL DUPLEX].
[STANDARD FDDI] is the default setting for the SET
OPERATION MODE field of the DELHF-UA.
3. With [FULL DUPLEX] selected, use the arrow keys to highlight the
SAVE command at the bottom of the screen, then press ENTER. The
"Saved OK" message displays indicating that the changes have been
saved to memory.
When the SAVE command is executed, both ports of the
DELHF-UA begin operating in full duplex mode.
3.10 THE FDDI/ETHERNET TRANSLATION
CONFIGURATION SCREEN
To access the FDDI/Ethernet Translation Configuration screen from the
DELHF-UA Setup screen, use the arrow keys to highlight the
FDDI/Ethernet Translation Configuration menu item on the
DELHF-UA Setup screen and press ENTER. The FDDI/Ethernet
Translation Configuration screen, Figure 3-15, displays.
DELHF-UA User's Guide
The FDDI/Ethernet Translation Configuration Screen
3-29
Advertisement
Table of Contents
