Table of Contents
Advertisement
Chapter 3: Local Management
Making a connection between the A ports of both devices to
the B ports of both devices (as is done with a DAS in normal
FDDI operation) DOES NOT create a redundant path when
using full duplex FDDI.
3.9.2
Full Duplex Configuration Screen Fields
The following list describes each of the Full Duplex Configuration screen
fields:
Operation Mode
This is a read-only field that displays the current operating parameters of
the port. This field reads "Standard FDDI" or "Full Duplex".
Link Status
This is a read-only field that will display "Link" or "No Link".
Port Status
This is a read-only field that will display "Enabled" or "Disabled".
SET OPERATION MODE
This field toggles between [STANDARD FDDI] and [FULL DUPLEX].
To change the current selection, use the arrow keys to highlight the field
and press the SPACE bar.
DESIRED OPERATION MODE
This read-only field displays the desired operation mode of the
DELHF-UA. In some cases, the DELHF-UA will not begin operating in
full duplex mode immediately. This field confirms that changes to the
SET OPERATION MODE field have been saved, and the DELHF-UA is
in the process of changing to the operation mode that is displayed in this
field.
SAVE
This command saves all configuration changes to memory.
3-28
DELHF-UA User's Guide
Advertisement
Table of Contents
