Table of Contents
Advertisement
7 - COLOUR TOUCH SCREEN INTERFACE
PARAMETER SETTING
7.1 - Main Configuration Menu
The "Setup" display is only possible on the unit touch screen.
To access the main configuration menu, press anywhere and
at any time on the screen (excluding buttons or text fields)
for 4 seconds.
By default, access to the menu is not password-protected.
The main configuration screen gives access to various unit
parameters:
I
1
System properties for the Ethernet interface
2
Connection configuration, web welcome page
3
System: Software version, Buzzer
4
Display: Contrast, backlighted
5
Keyboard: Not applicable
6
Password for "Setup" access
7
Languages: for "Setup" only
8
Return to application
7.2 - Find and Modify the Unit IP Address
In the main configuration menu (see chapter 7.1) press on
the network field "Network" to display the screen below.
1
Enable DHCP
2
IP address
3
Subnet mask
4
Default gateway
5
Primary DNS Server
Secondary DNS Server
6
B
C
D
E
F
G
H
B
C
D
E
F
G
If "Enable DHCP" is checked, PIC 5+ will automatically
get IP settings from DHCP server, no need to set other items.
NOTE: You must request an IP address, the subnet mask
and the default gateway from the network administrator
before connecting the unit to the local Ethernet network.
To change IP address manually, press on the second line with
the IP address.
Enter the new address and validate it by pressing "OK" .
Proceed in the same way with other network parameters.
Return to the application and save.
7.3 - Configuration of the Web Connection
This configuration is carried out at the factory and is not
normally modified.
In the main configuration menu (see section 7.1), press on
the "Web Connection" field.
The screen presented below is displayed:
Press "Edit Connection"
B
C
D
E
F
47
Advertisement
Table of Contents
Troubleshooting
