High-Speed Stack Connections; C2H124-48P Stackable Switch - Enterasys SecureStack C2 C2G124-48P Hardware Installation Manual

Overview
The 10/100 Mbps fixed front panel ports can operate in either half‐duplex or full‐duplex
mode, as determined by Auto‐Negotiation.
Figure 1-2
Á
1 DB9 RS232 console port connector
2 System Status LEDs
3 Twenty-four RJ45, 10/100 Mbps, PoE ports
4 RJ45 port status LED
5 Four slots for SFP interface modules
(Mini-GBICs)

High-Speed Stack Connections

The switch has rear‐panel connectors for high‐speed connections in a stack configuration.
The high‐speed stacking cables used for the connections are optional items and must be
ordered separately. There are two types of cables:
• a C2CAB‐SHORT cable to connect two adjacent switches in the stack, and
• a C2CAB‐LONG cable to connect from the top switch to the bottom switch in the
stack. You need only one C2CAB‐LONG cable per stack.
1-4 Introduction
Caution: The C2G124-48P is a PoE-compliant device. Do not connect a SecureStack C2
Redundant Power System (C2RPS-SYS) to the power connector. Otherwise, damage to
the device may result.
Precaución: El dispositivo C2G124-48P cumple con el estándar PoE. No conecte una
fuente de poder redundante SecureStack C2 (C2RPS-SYS) al cable de corriente directa.
De lo contrario, el dispositivo puede dañarse.

C2H124-48P Stackable Switch

Æ Ç
S
Ã
Â
È
6 Mini-GBIC port status LEDs
7 Two ports for stack connections
8 Password Reset switch
9 AC power input connector
10 Redundant power supply (RPS) DC
connector
Å
Ä À
É