Altronix eFlowNAD8 Series Quick Start Manual page 9

Fig. 3 - eFlowNA8D Series Configuration
Unswitched 120VAC
power mains
(non power-limited)
Optional Rechargeable Stand-by Battery
Note: 12V batteries required for
ULC-S319 installations.
CAUTION: When power supply board is set for 12VDC use only one (1) 12VDC stand-by battery.
Keep power-limited wiring separate from non power-limited. Use minimum 0.25" spacing.
12AH Rechargeable batteries are the largest batteries that can fit in this enclosure.
A UL listed external battery enclosure must be used if using 40AH or 65AH batteries.
eFlowNA8D Series Installation Guide
L G N
IN GND IN GND IN GND IN GND
1
F1 F2
DC Output to devices (power-limited)
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
OUTPUT 1 OUTPUT 2
for UL294 Applications
Fig. 3a
eFlow4NB - power-limited
eFlow6NB, eFlow102NB,
eFlow104NB - non power-limited
Battery and AC
Supervision Circuit
(power-limited)
AC1
NC C NO NC C NO
AC FAIL BAT FAIL
Input (power-limited)
IN GND IN GND IN GND IN GND
5 6 7 8
2 3 4
F3 F4 F5 F6
OUTPUT 3 OUTPUT 4 OUTPUT 5
Optional Rechargeable Stand-by Battery
Enclosure
Edge of
Enclosure
Tamper Switch
(included)
To Access Control Panel or
UL Listed Reporting Device
OFF - 24V
ON - 12V
power-limited
AC DC
TRIGGER EOL NO GND
+AUX-
SUPERVISED RESET
FACP
TRIGGER
TRG
INPUT
F7 F8
O N O N
O N O N
1 1 2 2 3 3 4 4 1 1
OUTPUT 6 OUTPUT 7 OUTPUT 8
for UL294 Applications
Note: 12V batteries required for
ULC-S319 installations.
Tamper Switch
2 2 3 3 4 4
MAIN
10A 250V
- 9 -