Table of Contents
Advertisement
There are two categories of commands in the command set.
•
Built-in Commands – Allow the user to access and manage network devices. The commands are
arp, bridge, defroute, netstat, ping, reset, show, traceroute, soft_reset, telnet, link_trap,
cdp, loopback_detect, arp_learn, atm_stp_state,
gigabit interface module is installed), vrrpPort, stpStandby, stpPort, lg_frame_admin,
dynamic_egress, and radius. The atm_stp_state command only displays when an HSIM or
VHSIM is installed that supports ATM, such as the HSIM-A6DP or VHSIM-A6DP.
•
Special Commands – Allow the user to exit from Network Tools. The commands are
or
exit.
NOTE: The conventions used in describing the commands in Network Tools are as
follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in
bold font
.
To abort the output or interrupt a process, press the CONTROL key and c key
simultaneously, designated as ^C here.
The commands are presented in the following format:
command
Description:
Briefly describes the command and its uses.
Syntax:
Shows the required command format. It indicates where arguments, if any,
must be specified.
Options:
Lists any additional fields in the appropriate format that may be added to the
command.
Example:
Shows an example of the command.
gigabit_port_mode
Network Tools Screens
Network Tools
(only appears if a
done, quit,
11-3
Advertisement
Table of Contents
