802.1X Access Control - Panasonic PN28240i Operation Manual

3.2.8.

802.1X Access Control

Select "Advanced Config" and "802.1X Access Control" to open the screen shown
in Figure 3-33. On this screen, you can configure port-based access control using
IEEE802.1X.
Figure 3-33 802.1X Port Based Access Control Configuration
Screen Description
NAS ID Displays the authentication ID (NAS Identifier) .
Port Number Displays the target port number.
Initialize Initializes the authentication status.
Re-auth Initialize Initializes the re-authentication status.
Port Status Displays the authentication status. This status reflects the Port Control setting
listed below.
Unauthorized
Authorized
Port Control Displays the operation for authentication request.
Auto
Force Unauthorized
Force Authorized
Transmission This is the time interval until a retransmission request is sent to the client. The
Period factory default setting is 30 seconds.
Supplicant Time- Displays the timeout time for the client. The factory default setting is 30 sec-
out onds.
The authentication is denied.
The authentication is approved.
Enables the authentication function and ignores all the
authentication requests from a client.
Disables the authentication function and blocks all com-
munications.
Disables the authentication function and permits all
communications. (Factory default setting)
57