Table of Contents
Advertisement
3.1.2.
IP Config
Select "Basic Config" and "IP Config" to open the screen shown in Figure 3-2. On
this screen, you can configure the IP address of this switch.
Screen Description
MAC Address
Displays the MAC address of this switch.
This item is uniquely assigned to each device and cannot be changed.
IP Address
Displays the current IP address.
"0.0.0.0" is the factory default setting.
Subnet
Displays the current subnet mask.
Mask
"0.0.0.0" is the factory default setting.
Default
Displays the IP address of the router, set as a current default gateway.
Gateway
"0.0.0.0" is the factory default setting.
IPv6 Status
Displays whether access via IPv6 is enabled or disabled.
Enable
Disable
IPv6 Link Local
Displays the current IPv6 link local address. "::" is the factory default setting.
Address
IPv6 Address
Displays the current IPv6 address and prefix length. "::/128" is the factory default
/Prefix Length
setting.
IPv6 Default
Displays the IPv6 address of the router, set as a current default gateway. "::" is the
Gateway
factory default setting.
Figure 3-2 IP Config
Enables access via IPv6.
Disables access via IPv6. (Factory default setting)
19
Advertisement
Table of Contents
