Table of Contents
Advertisement
2.2.
Access to Web Control Function
To use the Web control function, enter the IP address of this switch in the address
bar of your Web browser and press the Enter key. Then, a login screen, similar to
Figure 2-1, is displayed. Enter your user name and password.
The factory default user name is "manager" and password is "manager."
Note:
If the login screen is not displayed, check the following:
(1) Are the IP address, subnet mask and default gateway of this switch
properly configured?
(2) Is the IP address of this switch entered on the Web browser?
(3) Is the Web control function enabled?
(4) Is the IP address of the terminal to be accessed equal to the network
address of this switch?
When the above information has been authenticated properly, the screen shown
in Figure 2-2 will appear for selecting a display language.
Select the type of the language in which you want to show menus, and press "OK."
Figure 2-1 Login Screen
12
Advertisement
Table of Contents
