Specific Safety Instructions - Craftex CX110 User Manual

Extreme caution should be used when operating all power tools. Know your power
tool, be familiar with its operation, read through the owner's manual and practice safe
usage procedures at all times.
Always read and understand the user
manual before operating the machine.
Connect your machine only to the
matched and specific power source.
Always wear safety glasses when
operating your machine.
This machine is designed to cut metal
construction materials
shapes and profiles.
may be required
workshops, machinist
general construction work.
To obtain good running-in of the
machine it is advisable to start using it
at intervals of about half an hour. This
operation should be repeated two or
three times, after which the machine
may be used continuously.
Disconnect the power source when
changing blade and / or making
adjustments.
The safety instructions given above can not be complete because the environment in every
shop is different. Always consider safety first as it applies to your individual working
conditions.
SAFETY INSTRUCTIONS
of different
The materials
for fabrication
shops, and
WARNING!
Always check that the work-piece is
securely clamped and that long pieces
are suitably supported.
All operations must be performed with
the guards in place to ensure safety.
Immediately release the start/run/trigger
button if the blade should get stuck in a
cut. Switch off the machine before
raising the machine head. Then open
the vise and remove the work-piece.
Lastly, check the blade teeth for any
damage. If any of the teeth are broken,
replace the saw blade.
Always make sure that any tools used
for adjustments are removed before
operating the machine.
Make sure you
understood all the safety instructions in
the manual and you are familiar with
your CX110, before operating it. Failure
to do so, could result serious personal
injuries and damage to the machine.
have read and
3