Cx102 Specific Safety Instructions - Craftex CX102 User Manual

SPECIFIC SAFETY INSTRUCTIONS
CX102 is designed to cut wood only. Do
not cut metal.
ALWAYS inspect the blade for any
crack or missing teeth before operating
the band saw.
ALWAYS ensure that the blade tension
is properly set for the type and width of
blade installed.
NEVER place your fingers or hands in
the line of cut. If you slip, your hands or
fingers may come into contact with the
blade. Always use a push stick when
ripping narrow pieces.
DO NOT back the work-piece away from
the blade while cutting. Always turn off
the machine if you are backing out a cut.
ALL THE GAURDS must be in place
while operating the band saw to ensure
safety.
ALWAYS feed the stock smoothly. Do
not force or twist the work-piece while
cutting.
ALWAYS ensure that the band saw
blade guard is no more than 1/2" above
the stock.
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions.
CX102 – 22" BAND SAW
WARNING
MAKE SURE before
adjustments, the switch is in the "OFF"
position and the cord is un-plugged.
NEVER LEAVE
unattended while it is running.
DO NOT attempt to remove jammed
pieces unless the band saw has come
to a complete stop and the power switch
has been turned to the OFF position.
NEVER turn ON the band saw if the
blade is in contact with your stock.
ALWAYS ensure that the guide blocks
are properly set to prevent blade
wander.
ALWAYS make
bearings are properly adjusted to guide
the blade.
MAINTAIN AND SERVICE your band
saw regularly as instructed in the user
manual.
MAKE SURE you have read and
understood all the safety instructions in
the manual and you are familiar with
your band saw, before operating the
CX102. If you fail to do so, serious injury
could occur.
making any
the band saw
certain that the
4