Specific Safety Instructions - Craftex B2062L Owner's Manual

4
B2062L 12" LEFT TILTING ARBOR TABLE SAW

SPECIFIC SAFETY INSTRUCTIONS

NEVER attempt to remove jammed cutoff pieces until the saw blade has
come to a full stop.
NEVER use a saw blade that has a.) Missing carbide teeth, b.) Loose
teeth, c.) Chipped or broken teeth.
NEVER stand directly in line with the saw blade when feeding stock into
the saw.
NEVER allow visitors or helpers to stand in line with the saw blade.
NEVER allow anyone to "assist" you by holding your workpiece at the
outfeed end.
NEVER attempt to cut stock "freehand", always use the rip fence or mitre
gauge.
NEVER use the Rip Fence and the Mitre Gauge together.
ALWAYS make sure that the rip fence is properly squared to the saw
blade to prevent kickback.
ALWAYS make sure that your saw is in a stable position. Cutting heavy,
long stock may alter the stability of the B2062L. In the event that this may
occur, the saw should be firmly bolted to the floor.
ALWAYS be sure that the mobile base wheels are firmly locked before
turning the saw on.
ALWAYS use an outfeed table or roller stand to support long pieces of
stock.
ALWAYS use a feather board and/or hold-downs to support your
workpiece when necessary.
ALWAYS turn the saw off in the event of a motor stall or blade jam before
attempting to remove the stock.
ALWAYS use only those accessories designed specifically for the B2062L
Table Saw.