Mounting - Craftex CX407N User Manual

MOUNTING

The CX407N can be mounted in three
ways:
TABLE TOP MOUNT: Using rubber feet
and/or the flush mount flange brackets for a
table-top application.
HANGING MOUNT: Using the eye bolts for
a high ceiling application.
FLUSH MOUNT: Using the flange brackets
for a wall or low ceiling application.
WARNING!
Make sure the air cleaner is OFF and the
cord is disconnected from the power
source while
servicing and
maintenance job.
TABLE TOP MOUNT
The CX407N can be used as a portable air
filtration system by installing the rubber feet
and placing the unit on a work-bench or a
table.
To set up the air cleaner for table top
operation:
Get the help of an assistant and carefully
place the air cleaner unit upside down.
The rubber feet feature sticky backing.
Attach the rubber feet to the bottom of the
air cleaner as shown in figure-4.
For permanent table top mounting, refer to
the Flush Mount procedure on page-9 and
install the unit on the table top with the flush
mount flange brackets.
installing, removing,
performing
Figure-4 Rubber feet attached to the bottom
of the air cleaner unit
HANGING MOUNT
The CX407N can be hung from the ceiling,
operating at an optimum height from the
any
floor.
To install the CX407N, hung from the
ceiling:
Install four chains, cable or steel strapping
lines to the ceiling from the support or joist
capable of holding 105 lbs.
Remove the plug screws and retain these
screws as you will need to reinstall them to
seal back the air filter unit when eye bolts
are removed.
Figure-5 Removing the plug screws
8