Control Panel - Craftex CX407N User Manual

Place the flange bracket under the air
cleaner lip at the mounting hole location
and secure it using screws and washers
provided as shown in figure-7.
Install the other three flange brackets in the
same manner.
For permanent table top mounting, use the
lower lip holes.
Figure-7 Mounting flange bracket to the air
cleaner
Get the help of an assistant or a friend to lift
the air cleaner and secure it to the wall or
the ceiling using screws and washers
provided).
WARNING!
Do not use support rated for a less
minimum of 150 lbs working load. Do not
use fasteners that can tear out and make
the air cleaner fall down.
Failure to follow these instructions may
result in serious damage (to the unit),
injury or death.

CONTROL PANEL

The CX407N control panel allows you turn
the air cleaner ON and OFF manually and
set the fan speed.
The control panel features two buttons:
OFF and ON/SPEED.
OFF Button: Allows turning the air cleaner
(not
OFF manually.
ON/SPEED Button: Allows turning the air
cleaner ON with one push of the button and
for every additional push, the fan cycles
from Low to Medium to High. The speed
selection is indicated by a red LED light.
Figure-8 Control panel
10