Emc Tables - Eighteeth Fast-Fill User Manual

1 do tekstu, który ma się tutaj pojawić.
tosować 标题 1 do tekstu, który ma się tutaj pojawić.

11.EMC Tables

Guidance and manufacturer's declaration – electromagnetic emissions
The Fast-Fill is intended for use in the electromagnetic environment specified below. The
customer or the user of the Fast-Fill should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions
IEC61000-3-2
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The Fast-Fill is intended for use in the electromagnetic environment specified below. The
customer or the user of the Fast-Fill should assure that it is used in such an environment.
Immunity test IEC 60601 test
level
Electrostatic +/- 8 kV contact
discharge (ESD)
IEC 61000-4-2 +/- 2 kV, +/- 4 kV,
+/- 8 kV, +/- 15 kV
air
Błąd! Użyj karty Narzędzia główne, aby zastosować 标题
Błąd! Użyj karty Narzędzia główne, aby zas
Compliance Electromagnetic environment - guidance
The Fast-Fill uses RF energy only for its internal
function. Therefore, its RF emissions are very low
Group 1
and are not likely to cause any interference in
nearby electronic equipment.
Class B
The
Class A establishments, including domestic establishments
and those directly connected to the public low-
voltage power supply network that supplies
buildings used for domestic purposes.
Complies
Compliance level
+/- 8 kV contact
+/- 2 kV, +/- 4 kV,
+/- 8 kV, +/- 15 kV
air
Fast-Fill is suitable
Electromagnetic
environment - guidance
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the relative
humidity should be at least
30 %.
for use in all
Page
32 / 37