Eighteeth Fast-Fill User Manual page 26

1 do tekstu, który ma się tutaj pojawić.
tosować 标题 1 do tekstu, który ma się tutaj pojawić.
Preparation
before
2
cleaning
The following Step 3 to Step 5 are operated in a washer-disinfector:
WARNING
⚫ Use only approved washer-disinfectors according to EN ISO 15883,
maintain and calibrate it regularly.
⚫ Follow instructions and observe concentrations given by the manufacturer
(see general recommendations).
⚫ Sufficient rinsing step should be available in purified water (max 10
germs/ml and max 0.25 endotoxin units/ml)
⚫ Avoid any contact between the cartridge nut and any instrument, kit,
support or container.
⚫ Make sure the components are dry before moving to the #6 step.
Cleaning:
Automated
3
4 Disinfection:
Thermal
5 Drying
6 Maintenance
and
Błąd! Użyj karty Narzędzia główne, aby zastosować 标题
Błąd! Użyj karty Narzędzia główne, aby zas
agents to the components.
⚫ Silver tubes are single use only and shall be
disposed of according to the local environmental
protection laws and regulation.
Remove and disconnect the Cartridge nut before
cleaning. Refer to "Chapter 4-Installing the Fast-Fill"
of this manual for disassembly instructions.
Observe suitable personal protective measures.
Carefully put the components (Cartridge nut and
Bending Tool) into the washer-disinfector and set the
parameters as follows:
Pre-cleaning: water temperature <30℃, 2 min;
-
Cleaning: water temperature 45℃, 5 min; use an
-
enzyme detergent
solution) which is suitable to be used with washer-
disinfector, and use in accordance with the IFU of
the detergent solution manufacturer;
Rinsing: water temperature 45℃, 1 min (rinsing
-
twice).
Thermal disinfection at least 5 min at 90℃/194°F,
make sure A0 value≥3000.
Rinse with purified water at 70°C for 1 minute.
Heat, 20min, 90℃/194°F
Inspect components and sort out those with defects.
Dirty components must be cleaned and disinfected
solution (aldehyde free
Page
26 / 37