Card Movement; Figure 113 Print Head Angle - idp SMART Series User Manual

5. Calibration of Print Head Angle
To get the best print quality, the TPH
should be located vertically with card
surface.
If print quality has the problem, it
could be caused by print head angle.
Through Adjusting print head angle
by screw (red mark in the right
picture), you could make good quality
of print.
(Use the appropriate screw driver to
adjust, and turn the screw by 90
degrees at a time.)

6.4. Card movement

6.4.1. Cards can't enter into the printer from input hopper.

Non-standard cards or bad cards.
Change the cards. You can use only ISO CR-80 card (54mm x 86mm).

Card thickness control lever is set improperly.
Regulate the card thickness control lever to fit the current card thickness.

Bad card array.
Array the cards again and put them on input hopper as section 2.2 in this manual.

Cards have static and moisture.
Remove the moisture or static.
6.4.2. Card Transfer Error occurs when the ribbon is coiled around the transfer
roller or the printing roller.
Open the top cover and remove the card and the coiled ribbon from SMART-51
printer using front LED buttons. If this problem occurred frequently, check the below
things.
 Non-standard cards or bad cards.
Change the cards. You can use only ISO CR-80 card (54mm x 86mm).
 The transfer roller or the printing roller is contaminated with the dust and dirt
Remove the dust and dirt with the cleaning kit as section 6.1

Figure 113 Print head angle

86