idp SMART Series User Manual page 62

④ Batch Start: Repeat selected encoding test by "⑤ Encoding"
⑤ Encoding: Encode Magnetic Stripe, Contact Card, Contactless Card
⑥ Printer Status: Check printer status.
⑦ Message: Description of status by log.
(2) Select printer and control
When you execute CardPrinterTest, it will search connected printers by USB and Network
automatically and SMART-51 printer connected to USB has higher priority. Other printers could
be selected by pull-down menu. You can test all function with connected printer.
. Control is consisted by SBS(Step by Step), Move, Rotate, Etc. section and you can control
printer by each step.

SBS
SBS is to operate SMART-51 printer in SBS(Step-By-Step) mode which you can
control the printer using commands. In SBS mode, after printing data transmission,
printing a card will be run only by clicking "DoPrint". It is the main difference between
NORMAL mode and SBS mode. When you click "Start", SMART-51 is operated in
SBS mode, and existing spooled data will be eliminated. To exit SBS mode, click
"Stop".

Card
Card is to bring a card into printer and eject a card. "In" is to move a card from input
hopper to printer and "Out" is to move a card from printer to output hopper. In case
the flipper is installed, "Back" ejects a card to the back side.

Move
Move is to move a card to specific position in the inside of printer. "Print" is to move a
card to the printing position, and "Mag." is to the magnetic encoding position, and "IC"
is to the contact smartcard encoding position, and "RF" is to the contactless
smartcard encoding position. "To Rotator" is to move a card from printer to flipper and
"From Rotator" is to move a card from flipper to printer. "from In" is to move a card
from the card in sensor to where you define position, and "from Out" is to move a card
from the card out sensor to where you define position.
62