Set-Up & Assembly; Storage - H&S GM 170 Operator's Manual And Parts List

SET-UP & ASSEMBLY
WHEELS & TIRES
The Grinder-Mixer is shipped without the rims and tires installed on the axle hubs. Install the rims and
tires, and torque the wheel nuts to 90 ft.-lbs. (124 N-m). Inflate the 12.5L x 15 - 20 ply tires to 80 PSI (563
kpa).
DRAIN PLUGS & DRAIN COVER
When the Grinder-Mixer is delivered, the drain plug on the back plate of the transfer auger will be in the
storage position. See the diagram below for the storage position. When the GM 170 is ready for delivery,
install the drain plug in the back plate of the transfer auger. Make sure that the drain plug below the
supplement hopper in the transfer auger is also installed. If the mixer is equipped with a Swinging Intake
Auger (SIA), the drain plug will also be in the storage position. Upon delivery, also install the drain plug in
the drain hole in the bottom of the SIA attachment.
IMPORTANT: Never open or plug the water drain holes with the mixer running.
Transfer Auger Drain Plug In Storage Position.
SIA Drain Plug In Storage Position.
Transfer
Auger
Drain
Plug

STORAGE

IMPORTANT: If the GM 170 is stored outside, the water drain holes must be left unplugged. Before the
mixer is going to be operated, reinstall the plugs. After a rain, check the mill, mixing tank, and augers for
water accumulation before operating the mixer. As necessary, drain the water before using the mixer.
NOTE: After water has been drained from the mixer, it is advisable to run the GM 170 while empty for a
period of time in an attempt to dry the mixer before grinding to eliminate any sticking of material and
possible plugging.
-14-