Set-Up & Assembly - H&S Top Shot 5215 Operator's Manual

WARNING: Some photographs used in the following pages show guards or
shields removed for clarification. Never operate machine until these guards or
shields are in proper operating position.
NOTE: Determine right or left side of the Manure Spreader by viewing it from the rear. If instructions
or parts lists call for hardened bolts, refer to the Cap Screw Torque Value page to identify.
WHEELS & TIRES
The Top Shot may be shipped without the wheels/tires installed.
1. Attach the wheels with tires using the lug nuts furnished, and torque the mounting hardware to
the appropriate torque listed in the Service Chapter. Check wheel bolts periodically thereafter.
2. Inflate the tires to the appropriate pressure listed in the Service Chapter.
3. Check the Top Shot for proper assembly and adjustment and make sure that all bolts are
tightened.
4. Securely retighten after a few hours of operation, as bolts can loosen up on new machinery.
5. Lubricate the Top Shot completely.
SET-UP & ASSEMBLY
-15-