Set-Up & Assembly - H&S 4142 Operator's Manual

WARNING: Some photographs used in the following pages show guards or
shields removed for clarification. Never operate machine until these guards
or shields are in proper operating position.
NOTE: Determine right or left side of the Manure Spreader by viewing it from the rear. If instructions
or parts lists call for hardened bolts, refer to the Cap Screw Torque Value page to identify.
PREPARING MANURE SPREADER
The Manure Spreader may be shipped without the wheels/tires installed.
1. Attach the wheels with tires, using the lug nuts furnished and torque the mounting hardware to the
appropriate torque.Wheel bolts should be tightened at 100 ft/lbs. of torque
on 4142 and 300 ft/lbs. of torque on the 4155.
2. Check the tires and inflate to the recommended pressure(425/65R-22.5 tires to 85 psi.).
3. Check for proper assembly and adjustment and make sure that all bolts are tightened.
4. Securely retighten after a few hours of operation, as bolts can loosen up on new machinery.
5. Lubricate the machine completely, check the oil level of the gearbox, fill if necessary. Check the
automatic oiler level if spreader is equipped, fill if necessary.
SET-UP & ASSEMBLY
-16-