Table of Contents
Advertisement
PROBLEM
Decreased or low capacity
Excess vibration.
Excessive dust.
Material not ground to desired
size.
Material will not flow through mill
hopper.
PROBLEM
Tank won't unload or stops
unloading.
Tank unloads too slow.
TROUBLESHOOTING
MILL
CAUSE
Mill not operating at the
recommended RPM speed.
Mill loses speed as material
enters it.
Hammers worn
Screen worn.
Blower inlet plugged.
Uneven flow of grain into the mill.
Excess RPM.
Mill bearings worn or defective.
Flywheel bearings worn or
improperly adjusted.
Hammers missing or
Blower unbalanced.
Blower inlet plugged.
Collector covered.
Incorrect screen being used.
Mill speed too high or low.
Mixer is sloped towards the
feeding side.
Material too damp.
Material too light or bulky.
UNLOADING
CAUSE
Bridging in tank.
Discharge slide is not open all
the way.
-40-
Adjust tractor throttle to proper
RPM speed.
Adjust Mill/Blower sheave
alignment and/or drive belt
tension.
Flip/turn or replace hammers.
Rotate or replace screen.
Unplug.
Transfer grain into the mill as
smoothly as possible.
Operate at 540 RPM.
Replace bearings.
Replace and/or properly adjust
bearings.
broken.
Replace hammers.
Remove, balance &
Check & unplug.
Uncover collector while
operating.
Change screen diameter to
correct size.
Adjust to correct RPM speed.
Reposition mixer on level
ground.
Adjust slope of intake hopper.
Adjust slope of intake hopper.
Shut-off mixer and tractor, break
up bridging by probing through
the access doors.
Open slide up more.
REMEDY
replace.
REMEDY
Hide quick links:
Advertisement
Table of Contents
