Table of Contents
Advertisement
MILL/BLOWER DRIVE
The combination
mill/blower driven sheave is connected from the main drive sheave by an 8" "A" section
banded drive belt. Adjusting bolts are provided to align the drive sheave with the driven sheave as well as
to adjust the drive belt tension.
C
D
Sheave Alignment
To align the combination mill/blower driven sheave with
1. Loosen both of the bolt/nut (A & B) assemblies on the
2. Place a straightedge across the faces of both sheaves (C & D) to check alignment.
3. Adjust the nut on the left bolt assembly (A) and the bolt on the right side assembly (B) to bring
the drive sheave into alignment with the driven sheave.
4. After proper alignment is obtained, check and adjust drive belt tension.
Belt Tension
To adjust mill/blower drive belt tension, proceed as follows:
1. Check the drive belt tension initially by
midway point between the sheaves while applying 60 lbs. of force at the midway point.
2. Adjust the nut on the left bolt assembly (A) clockwise
and adjust the right side bolt assembly (B) an equal number of turns counterclockwise to keep
drive sheave in alignment with driven sheave. Adjust both sides until the deflection measures
3/8" (10 mm).
3. After proper tension is obtained, check for correct sheave alignment, retighten the lock nut on the
right side bolt.
NOTE:A new drive belt should be adjusted for an initial tension of 3/8" (10 mm) deflection with an applied
pressure of 80 lbs. (360 N). Refer to the Service chapter of this manual for new belt installation procedures.
ADJUSTMENTS
the drive sheave, proceed as follows:
measuring the amount of belt deflection at the
-26-
A
B
main drive shaft.
to decrease deflection (increase tension)
Hide quick links:
Advertisement
Table of Contents
