Skoda FABIA 2000 Workshop Manual page 40

15
removing and installing ⇒ 15-1 page 2
after replacing fill entire system with fresh coolant
15 - Oil deflector
16 - 25 Nm
17 - Lifting eye - on the right
18 - Gasket for cylinder head cover
replace if damaged
19 - Cylinder head cover
20 - Cap
fit on during installation work
Fig. 1: Inspecting the cylinder head for distortion
Special tools, test and measuring equipment and
auxiliary items required
♦
Straightedge
♦ Feeler gauge
Max. permissible distortion: 0.05 mm (minimum clear-
ance of straightedge base: 100 mm)
If the distortion is greater than 0.05 mm, replace cylinder
head, do not rework.
Removing and installing cylinder head
•
Engine installed
Special tools, test and measuring equipment and
auxiliary items required
♦ Catch pan (e.g. -V.A.G 1306-)
♦ Torque wrench
♦ Pliers for spring strap clips
♦ Flat scraper
♦
Braking agent -AMV 105 500- (Loctite 242)
Removing
–
On models fitted with a coded radio set, first deter-
mine the coding.
–
Disconnect the battery-earth strap with the ignition off.
Note
When the battery is disconnected and reconnected, carry
out rework ⇒ Electrical System; Rep. Gr. 27.
–
Remove front exhaust pipe with catalyst ⇒ Chapter
26-1.
–
Drain coolant ⇒ Chapter 19-1.
–
Removing engine cover ⇒ Chapter 10-1.
15-1 2
page
FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Removing and installing cylinder head
1 2
6
4
5
V15 - 0673
3
4
S10-0138
Edition 09.03
S00.5305.04.20