Skoda FABIA 2000 Workshop Manual page 16

10
Procedure
Installation is performed in the reverse order. Pay atten-
tion to the following points:
–
Check whether the dowel sleeves for centering the
engine/gearbox are present in the cylinder block; in-
sert if necessary.
–
If necessary check the centering of the clutch driver
disc.
–
Inspect clutch release bearing for wear, replace if nec-
essary.
–
Lubricate the drive shaft serration lightly with grease
-G 000 100 -.
–
Install the slave cylinder of the hydraulic clutch
⇒ Gearbox 002; Rep. Gr. 30.
–
Adjust the gearshift mechanism and cable control
⇒ Gearbox 002; Rep. Gr. 34.
–
When installing the engine/gearbox unit make sure all
adjoining components are clear.
–
Align the engine/gearbox unit.
Tightening torques ⇒ 10-1 page 9.
Vehicles with air conditioning
–
Install the AC compressor ⇒ Chapter 13-1.
–
Install alternator ⇒ Electrical System; Rep. Gr. 27.
–
Fit V-ribbed belt ⇒ Chapter 13-1.
Continued for all vehicles
–
Install the drive shaft on the right and left of the gear-
box ⇒ Chassis; Rep. Gr. 40.
–
Install the front exhaust pipe with catalyst and fit the
exhaust pipe free of stress ⇒ Chapter 26-1.
–
Electrical connections and cables ⇒ Current Flow Di-
agrams, Electrical Fault Finding and Fitting Locations.
–
Install coolant hoses ⇒ Chapter 19-1.
Note
The drained off coolant must only be re-used if the cylin-
der block, cylinder head, radiator or heat exchanger were
not replaced.
–
Top up coolant ⇒ Chapter 19-1
–
After connecting the battery:
Code radio.
Set clock.
Initialise power window lifter.
⇒ Inspection and Maintenance
–
Check oil level before starting the engine.
10-1 8
page
FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Removing and Installing Engine Edition 02.02
S00.5305.03.20