Skoda FABIA 2000 Workshop Manual page 36

13
7 - Cylinder block
seat surfaces for liners must be clean and flat
remove contamination on seat surfaces of the liners by cleaning only; do not use emery paper, flat scraper or
similar
8 - Conrod bolt, 20 Nm + torque a further
only 1.0 ltr. engine
replace
oil thread and head contact surface
9 - 40 Nm
only 1.4 ltr. engine
oil thread and head contact surface
10 - Conrod cap
check fitting position ⇒ item 5 in 13-3 page 1
11 - Bearing shell
do not mix up used bearing shells
1.0 ltr. engine insert in middle
1.4 ltr. engine ensure tightly located in retaining lugs
12 - Gasket ring
replace
different thicknesses are available to correct the liner pretension
13 - Liner
remove with -MP 1-105-
available as replacement part only as a set with pistons (4 in total)
check pretension ⇒ Fig. 4 in 13-3 page 3
14 - Circlip
15 - Piston pin
remove and install with -T10046-, if stiff, heat piston to 60 °C
Fig. 1: Inspecting piston ring gap clearance
Special tools, test and measuring equipment and
auxiliary items required
♦ Feeler gauge
–
Push in ring, at right angles about 15 mm away from
top edge of liner.
Piston ring 1.0 ltr. en-
dimensions gine
in mm
1. Piston ring 0,20...0,50
(chrome-plat-
ed)
2. Piston ring 0,20...0,50
(grey)
Oil scraper 0,40...1,40
ring
1)
no specification possible for wear limit
13-3 2
page
FABIA 2000
1 / turn (90°)
4
new
1.4 ltr. en- Wear limit
gine
0,40...0,72 1,0
0,30...0,62 1,0
0,40...1,40
--- 1)
Disassembling and Assembling Pistons, Connecting Rod and
1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Liner
S13-0006
Edition 06.00
S00.5305.01.20