Skoda FABIA 2000 Workshop Manual page 41

FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
–
Disconnect plug:
2 - from the throttle valve control unit -J338-
3 - from the intake manifold pressure sender -G71- with
intake manifold temperature sender - G72-
6 - from the coolant temperature sender -G62-
7 - from the injector cylinders - N30 bis N33-
–
Unclip edge connector -4- -arrows- and remove wiring
loom from holders.
–
Remove ventilation hoses -1- and -8-.
–
Remove intake hose -5-.
–
Disconnect air hose from hot air collector.
–
Remove coolant hoses -1- and -2- from the thermo
regulator housing.
–
Remove vacuum line from the brake servo unit.
–
Remove pipe supports for intake manifold.
–
Unscrew the guide tube for the oil dipstick from the ex-
haust manifold.
–
Remove ignition terminal.
Caution!
The fuel system is under pressure! Before opening
the system lay cleaning cloths around the connec-
tion point. Reduce pressure by carefully releasing
the connection point.
–
Remove the fuel presupply pipe -4- by pressing the re-
lease buttons at the separation point.
–
Remove the coolant hose -2- from the expansion res-
ervoir.
–
Release ventilation hose -3- from the solenoid valve.
–
Remove the cylinder head cover.
–
Release the cylinder head bolts/nuts (do not yet fully
unscrew).
–
First remove the rocker arm shaft.
–
Then unscrew the remaining cylinder head bolts/nuts.
–
Remove the generator support bracket ⇒ item 12 in
15-1 page 1
–
Prior to this remove the V-ribbed belt on vehicles with
air conditioning ⇒ Chapter 13-1.
–
Remove the push rods and lay aside according to
their fitting position.
–
Carefully remove the cylinder head.
Edition 09.03
S00.5305.04.20
1
Removing and installing cylinder head
1
4
7
8
2
3
15
2
5
3
6
S15-0157
1
S10-0141
2
4
S10-0137
15-1 3
page