Skoda FABIA 2000 Workshop Manual page 43

FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
–
Tighten the cylinder head bolts/nuts in the following
sequence:
Position Tightening method
1 to 10 Stage I: 20 Nm
Stage ll:
1
wrench
Stage lll:
1
wrench
11 to 14 20 Nm
–
Install the generator support bracket ⇒ item 12 in
15-1 page 1
Insert bolt ⇒ item 11 in 15-1 page 1 with locking
agent -AMV 105 500-.
–
Tighten the rocker arm shaft screws crosswise evenly
to 25 Nm.
–
Perform basic setting of hydraulic valve clearance
compensation ⇒ Chapter 15-2.
Note
The basic setting of the hydraulic valve clearance com-
pensation must not be carried out again, if only the cylin-
der head gasket is replaced.
–
Install the V-ribbed belt on vehicles with air condition-
ing ⇒ Chapter 13-1.
Further installation occurs in a similar way in reverse or-
der to removal. Pay attention to the following:
–
Install front exhaust pipe with catalyst ⇒ Chapter 26-
1.
–
Top up coolant ⇒ Chapter 19-1.
–
Adapt the engine control unit to the throttle valve con-
trol unit -J338- ⇒ 1.0/37; 1.4/44; 1.4/50 engine - fuel
injection; Rep. Gr. 24.
–
Perform a test drive, interrogate and erase fault mem-
ory ⇒ 1.0/37; 1.4/44; 1.4/50 engine - fuel injection;
Rep. Gr. 01
Edition 09.03
S00.5305.04.20
/ turn (90°) with a rigid
4
/ turn (90°) with a rigid
4
Removing and installing cylinder head
15
15-1 5
page