ThyssenKrupp TW160 Operating Manual page 91

Operating manual
TW160 drive
Item Designation
Tightening screw for
1
compression spring
3 Adjusting screw
5 Brake release lever
7 Motor
9 Gear drive
Fig. 9.2-1
1. If not included in the scope of supply, make 2 lines (3 x 0.75 mm² for SA3 and 2
x 0.75 mm² for SA3.1 with PVC sheaths) for direct connection of the switches to
the control system and connect the switches.
2. Mount the hexagon screws (microencapsulated) with lock nut to be adjusted on
the brake shoes (pre-assembled at the plant). The switch tappet on the sensor
must be opposite the setting screw, but should not make contact with it. 
9.2.2 Setting SA3
Before starting to set the sensor; the stroke of the brake shoes must be adjusted!
Description, see 
1. Switch on the emergency operation switch and elevator control system.
2. Adjust the setting screw for the switch.
3. The LED lights up.
4. Turn back the screw slowly.
5. The LED goes out.
6. Move the adjusting screw by ¼ turns (corresponds to approx. 0.3 mm) in the
direction of the switch and secure with a lock nut.
7. LED lights up continuously.
8. Open and close the brakes by switching the motor
9. In doing so, check that the sensors switch between open and closed brake.
9.2.3 Setting SA3.1
The break contact with contacts 11 and 12 is used to monitor the position of the brake
shoes. With the brake open, the switch is closed.
The make contact closes contacts 23 / 24 only when the wear limit of the brake linings
has been reached and the brake is closed. The contacts must be switched in such a
way that when one contact of both switches closes the drive is prevented from starting
up.
With a correctly set brake test switch, all switch contacts must be interrupted with a
closed brake.
Before starting to set the sensor; the stroke of the brake shoes must be adjusted!
Description, see 
thyssenkrupp Aufzugswerke
chapter 8.6
chapter 8.6
91
Special versions (optional)
Item Designation
2 Brake shoes
4 Test switch (sensor)
6 Pressure rod
8 Compression spring
Version 03/2019