ThyssenKrupp TW160 Operating Manual page 85

Operating manual
TW160 drive
Handwinding wheel hub with feather key and cover screw-connected on the
shaft end
There are two feather key grooves in the handwinding wheel borehole. When
pushing on the handwinding wheel, use the groove that matches one of the three
cast-on reinforcement ribs in the inside of the handwinding wheel (reduces
unbalanced mass at the handwinding wheel)
1. Insert the feather key in the groove.
2. Push the handwinding wheel onto the shaft end.
3. Mount the locking washer on the new handwinding wheel.
4. Use the flat countersunk nib bolt to secure it in the motor shaft borehole.
Handwinding wheel hub pinned on the shaft end with adapter sleeve
1. Push the hub onto the shaft end.
2. Align to the borehole.
3. Support the shaft end.
4. Mount the adapter sleeve 8x45 DIN 1481.
5. Push the handwinding wheel onto the hub.
6. Secure with Allen screws M8x16 DIN 7984.
Handwinding wheel hub with axial adapter sleeve (Motorlift motors)
1. Push the handwinding wheel and hub together onto the shaft end, pushing
2. Attach the screw in the middle of the handwinding wheel.
Concluding work
1. Secure the connection line to the motor with cable ties.
2. Connect the encoder connection cable to the frequency inverter.
3. Switch on the installation and perform a teach-in run for adjustment.
thyssenkrupp Aufzugswerke
the borehole in the hub onto the adapter sleeve.
85
Servicing and Maintenance
Version 03/2019