ThyssenKrupp TW160 Operating Manual page 58

Operating manual
TW160 drive
1. Bolt together the delivered base frame in the machine room.
2. Make sure that the supports are mounted with additional drilled holes (2
3. Mount and secure the deflecting pulley with axle on the pulley supports.
4. Set up and align the frame on the insulation elements according to the
5. Use lifting gear to place the machine on the base frame; the traction sheave
6. Balance out uneven surfaces by inserting the enclosed shims.
7. Bolt the machine onto the frame, whereby the machine housing must not be
8. Align the rope grooves of the traction sheave and deflecting pulley in parallel.
9. Tighten the screws with the prescribed tightening torque.  Chapter 10.2
10. Plumb the rope departure on the rope pulley at the elevator car and/or
With a horizontal rope departure, the gear housing on the machine base frame is to
be secured against shifting by means of car steady plates.
NOTE
Hazard with possible damage to property!
May lead to product function impairments or function loss.
With a side or oblique rope departure, the gear housing on the machine
base frame is to be secured against shifting by means of car steady
plates with set screws.
The arrangement of the suspension ropes in the suspension plates, on
the traction sheave as well as the rope pulleys must be as symmetrical as
possible.
The versions can be found in the general arrangement drawing.
thyssenkrupp Aufzugswerke
holes) and pulley support on the correct side.
general arrangement drawing.
must be on the deflecting pulley side
tensioned. (Balancing by means of the supplied shims)
mounting on the car and counterweight.
58
Installation
Version 03/2019