ThyssenKrupp TW160 Operating Manual page 38

Operating manual
TW160 drive
Item Designation
1
TW160 machine - SA4
Pedestal bearing housing
3
(external bearing)
5
Frame yoke
7
Rope guard
Mounting parts for machine base
9
frame
11
Machine room floor
Fig. 4.5-4
The machine base frame consists of a base frame with welded bearing bracket and a
frame yoke for holding the rope guards and the bolted sealing plate. The hole pattern
for mounting the machine and the position of the frame yoke are dependent on the
traction sheave diameter - DT and the traction sheave position - left or right.
It is possible for the customer to provide a vapour-proof enclosure of the entire
machine base frame by using side plates on the base frame and by using the profile
section of the frame yoke (U140).
The base frame is bolted to the machine room floor with heavy-load anchors (6 pieces
supplied). The arrangement is sealed against the machine room floor by the
customer.
Technical data
 Weight of machine base frame: approx. 350 kg
4.5.5 Mounting parts, TW160 base-frame-mounted machine
A set of bolting elements (4 x M20-8.8) is available (AY mounting parts 62 340 03 98
0) for mounting the TW160 machine on the standardised machine base frame with /
without rope pulley.
A reinforced mounting (6 x M20-8.8 / 2 x M16-8.8) is used (assembly, mounting parts
62 340 03 98 0) is used for individual applications of the TW160 machine with
horizontal or vertically upward rope departure - except for the special versions SA4/9.
thyssenkrupp Aufzugswerke
Item Designation
2
Compensating supports
4
Base frame
6
Sealing plate
Mounting parts for machine / base
8
frame
Vapour-proof partition wall
10
(supplied by customer)
38
Technology
Version 03/2019