Table of Contents
Advertisement
GLASS CRYSTAL BuRNER REmOVAL / INSTALLATION (HZI390E / HZI390EB)
Disconnect unit from gas supply and allow unit to cool before removing
burner.
GLASS BuRNER REmOVAL
1) If already installed, removed glass crystals and pebbles.
2) Remove filler sections from right and left sides of burner. Discard filler sec-
tion if panels are installed - see below.
Burner
3) Remove the 3 (some units may have 4) screws securing the burner feet
and into the Firebox floor - in locations shown below.
Burner Foot
Glass / Media Burner
4) Lift the burner assembly with both hands - pull the burner gently out-
wards and up towards the front of the firebox.
L390E / HZI390E Direct Vent Gas Insert
Filler section
Burner Cover Screen
Pilot Cover
Pilot Provision
Burner Foot
Burner Front
Mounting Tab
Glass / Media Burner
Front View
Glass Tray
Support
Mixing Tube
Rear View
GLASS BuRNER INSTALL
1) Lift the burner assembly with both hands. Point the mixing tube towards
the rear of the firebox. Lean the rear of the burner assembly downward.
To properly position the burner, the mixing tube must first situated onto
the mixing tube support. Partially lift the burner assembly so that the mix-
ing tube will then slide into the air shutter.
2) Lower the front edge of the burner assembly so that the burner front
mounting tab rests in the small slot in both the burner mounting bracket
left and right, near the front of the firebox. These tabs will not line up un-
less the mixing tube is inside the air shutter at the rear of the firebox.
Burner Mounting
Bracket Left
Gas Orfice
Mixing Tube
Pilot Assembly
Support
care must be taken when installing the burner into the firebox.
Front View
do not damage, knock or scrape the pilot assembly.
the flame sensor and ignition lead are fragile and can be damaged
Pilot Cover
Burner Screen
Burner
Glass / Media Burner
* Side view cut-through *
3) Place the Burner Cover Screen over the Burner Ports. Place the Pilot
Cover over the rear gap between the Burner and the Media Tray. This will
sit around the Pilot Provision.
4) Distribute the glass crystals throughout the Media Tray. The media should
be level with the side of the Media Tray.
** do not to install glass or other media over the pilot provision.
Mixing Tube
properly engaged
in Air Shutter
Properly positioned
Burner Tabs
mAINTENANCE
Air
Shutter
Burner Mounting
Bracket Right
Firebox
easily.
Fill Glass / Media
to this level
Glass / Media
Tray
Mixing Tube
Secure Burner
with 4x screws
43
Advertisement
Table of Contents
