Wiring Diagram; Proflame Remote System Gtm (L390E / Hzi390E) - Regency Fireplace Products L390E-NG Installation, Commissioning And Servicing Instructions

This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/thermostat will
continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
(do not cut the ground terminal off under any circumstances.)

PROFLAmE REmOTE SYSTEm GTm (L390E / HZI390E)

GtM reMote sYsteM - iMportant: The AA batteries in the receiver operate the unit. If the batteries become weak, they will need
CAuTION: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper and dangerous operation.
L390E / HZI390E Direct Vent Gas Insert

WIRING dIAGRAm

Proflame System
Configuration
Proflame System
Configuration
885 ON/OFF
886 GTMF
Illustrated wire diagram
Wire Diagram
SureFire™ Switch
0.584.907
Thermostat
(Optional)
to be replaced with quality AA alkaline batteries. The unit will not operate without AA batteries.
0.880.001
See optional wall thermostat
installation in this manual.
Caution: Ensure that the wires do not touch any
hot surfaces and are away from sharp edges.
installation
19