Operating The Fire With The Remote Control (Rc) Handset; Lighting The Fire; Adjusting The Flame Height - Valor Inspire 600FS Installer And Owner Manual

Basic operations of the fire with the Remote Control Handset.
Reference the remote control handset operation manual for all the features.-
Setting Fahrenheit or Celsius
- Setting the time
- Child Proof option
- Manual mode (handset)
- Standby mode (Pliot flame)
- Flame height adjustment
- Designated Low fire and High fire
Benchmark Commissioning and Servicing
- Countdown Timer
- Modes of operation
- Thermostatic mode
- Programe mode
- Eco mode
- Auxiliary feature (Rear burner operation)

Lighting the fire.

Press and hold the 'ON' button until a short acoustic signal
confirms the start sequence has begun; release button.
Continuing signals confirms the ignition is in progress. There
will be a slight delay and several sparks should be
between the electrode and pilot tip. Once pilot ignition is
confirmed there is main gas flow.
When pilot ignition is confirmed, motor turns automatically to maximum flame height.

Adjusting the flame height.

When the burner is operating press
the UP arrow button to increase the
flame height.
Note: Flame height can be adjusted
UP on a single burner or when the
two burners are lit at the same time
to get the desired output.
Press the DOWN arrow button to
decrease the flame height.
Note: Flame height can be adjusted
UP on a single burner or when the
two burners are lit at the same time to get the desired output.
©
GDC Group Ltd. AUG 2016
Section
www.centralheating.co.uk
Page 51
seen